|
      
Cold-Fusion Billet Midshaft Housing
Machined from billet components than bonded via high pressure vulcanization.
During fabrication we have also added special mechanical locking to the components in addition to the bonding to help insure years of trouble free service.
Currently available are housings for aftermarket hulls, (these will work in OEM hulls as
well, except they currently lack the ability to hold the rubber coupler cover post).
We will have this feature available sometime in the in the future.
Also, we have left out the zerk fitting as it tends to do more harm than good , we simply pack
grease between the 2 seals.
Contrary to popular belief, the OEM zerk does not lube the bearing
The barring carrier and seals are moved 2mm forward so they don't bind of flat firewalls common to aftermarket hulls.
Seal kits and shafts available separately.
Made right here in our facilities in the USA
$249.00 USD
|
